Formulated for unrivaled performance, Bore Tech Extreme CLP is a synthetic blend of oils, penetrants, friction reducing additives and enhanced rust and corrosion inhibitors. Extreme CLP breaks down and removes heavy carbon, lead, and powder fouling while providing unsurpassed lubrication and superior rust and corrosion protection. This highly effective one-step cleaner, lubricant and protectant was specifically formulated for use on all weapons system.

Extreme CLP’s technologically advanced formulation incorporates proprietary additives that penetrate deep into the metal’s pores and bond to the surface creating an enhanced film strength layer that provides superior anti-wear properties over a wide range of operating temperatures. Extreme CLP will not burn off under the extreme temperatures found during full auto fire or become sticky and gummy in the extreme cold temperatures with a -100˚F to 600˚F operating range.

Extreme CLP offers unparalleled protection against rust and corrosion by forming an effective barrier film that powerfully bonds to all surfaces and continues to condition the substrate over time. The micro thin film has surpassed 100 hours in the ASTM B-117 salt spray test and proven to effectively displace moisture and neutralize corrosive residues.

Bore Tech’s Extreme CLP is the premier and cutting edge choice for the extreme shooter, hunter or enthusiast looking for nothing but the best.

Features:

• Bottle Type: Treated HDPE Plastic
• Cap Type: Twist Open/Close Dispensing Cap w/ foam gasket seal
• 100% Barrel Safe
• Odor Free
• Non-Hazardous
• Contains No Ammonia
• Rust & Corrosion Preventative
• Non-Flammable

Bore Tech Extreme CLP use Instructions:

UNLOAD FIREARM

For Inside Bore:

1. Wet 3-4 Bore Tech X Count patches with Bore Tech Extreme CLP and individually push through bore to remove loose fouling.
2. Next, apply Extreme CLP to brush and make 10-15 passes through bore.
3. Then, repeat Step 1 & let soak for approximately 3 to 5 minutes. For badly fouled firearms, extended soak times may be necessary.
4. Finally, push dry patches through the bore until clean.
5. Repeat above steps if necessary.
6. Before storing firearm, dampen a patch with Bore Tech Extreme CLP and push through the bore to protect against rust/corrosion.
7. Before using firearm, run a dry patch through the bore to remove any residue and ensure against obstructions.

For Parts and Other Surfaces:

1. Apply Bore Tech Extreme CLP to fouled parts and surfaces.
2. Next, allow Extreme CLP to soak for 3 to 5 minutes. For badly fouled parts and surfaces,             extended soak times may be necessary.
3. Then, brush and wipe areas to remove all loosened debris and fouling.
4. Repeat above steps if necessary.
5. Finally, apply a thin layer of Extreme CLP to protect against rust/corrosion. Refer to your user manual for proper lubrication locations.